Mono Audio Amp Breakout - TPA2005D1

Mono Audio Amp Breakout - TPA2005D1

Mono Audio Amp Breakout - TPA2005D1 is a sound amplifier for any audio projects.

$6.78
Tax included Ships in 1-2 days.
 Last items in stock
 Customer ratings and reviews
Nobody has posted a review yet
in this language
  • Products in stock -  Same day shipping within business hours
Products on backorder - Usually ships in 10-15 working days depending on manufacturer Products in stock - Same day shipping within business hours Products on backorder - Usually ships in 10-15 working days depending on manufacturer
  • Return policy - Any product that is defective or damaged upon arrival can be replaced within 10 days Return policy - Any product that is defective or damaged upon arrival can be replaced within 10 days

DESCRIPTION

Audio amplifiers are basically said to enhance the quality of the Audio signals from low to high.

This tiny audio amplifier is based on the Texas Instruments TPA2005D1. Its efficient class-D operation means low heat and long battery life. It can drive an 8-Ohm speaker at up to 1.4 Watts; it won't shake a stadium, but it will provide plenty of volume for your audio projects.

The fully-differential inputs are safe for floating audio signals such as from our MP3 Shield, and can also be connected to ground-referenced signals as well. A shutdown input is provided to save power when the amplifier is not being used, and a solder jumper and header are provided to connect a volume-control potentiometer (not included).

Note: The amplifier's class-D design outputs a 250Khz PWM-like signal that is restored to an analog voltage in the speaker's coil. This is what makes the amplifier so efficient, but because of the switching frequency, you should keep the amplifier as close to the speaker as possible to minimize possible interference.

FEATURES

  • Extremely efficient class-D amplifier
  • 1.4W into 8 Ohms
  • 2.5V to 5.5V supply
  • Fully differential audio inputs, can be ground-referenced as well
  • Shutdown input with pullup and LED-follows-shutdown circuitry
  • PTH pads provided to change gain resistors if desired (see datasheet for details)
  • Solder jumper and header allow addition of a 10k volume control potentiometer (not included)

DOCUMENTS

SF-BOB-11044/03
1 Item
 Reviews

Be the first to write your review !